This website or its third party tools use cookies, which are necessary to its functioning and required to achieve the purposes illustrated in the cookie policy. If you want to know more or withdraw your consent to all or some of the cookies, please refer to the cookie policy. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies

Automatic panel type MPnano Engine Pump Control management and control motorpump

Automatic panel type
MPnano Engine Pump Control
management and control motorpump

The Panel combined with the pump unit, enabled the start-up of the same group within seconds of the start request, when opening or closing of a external contact. The electronic card of control to microprocessor is formed from a single card, with display of the programming and set parameters. Groups together all the functions of calibration needed for the management of the equipment. Considerable configuration possibilities according to the specific needed (firefighting equipment, irrigation, waste water, control levels, exc.)

Technical specifications

Control unit optimized for the command and control of pumps, compressors and motors in general
- Compact Design
- Large graphic display LCD back illuminated 128 x 64 pixel
- Communication through graphic symbols. No translation needed
- USB communication interface
- CanBus J1939 engine communication interface
- Battery prevention through modality ZERO ENERGY CONSUMPTION.
- Event Log

Types of operation
- Checking and adjusting the motor speed (RPM) manual or automatic
- Motor speed adjustment with pressure control system
- Automatic / manual or remote starting and stopping

Display Measures
- RPM motor
- State motor and Timer
- Running hours
- Motor oil pressure (analog)
- Motor temperature (analog)
- Fuel Level (analog)
- Battery voltage
- RPM required
- System pressure (analog)
- Pressure required (analog)
- Level START / STOP (analog)
- Display of alarms
- Historical events

Engine protections
- Over and Under Speed
- High Temperature (Analog or Digital)
- Oil Pressure (Analog o Digitale)
- Low Fuel Level (Analog or Digital)
- Battery Charger Alternator fail
- Low Battery Voltage

MPnano Compatibility CanBus
The management of motors can happen in traditional way or through connection CanBus SAE J1939 for the following motors : Caterpillar ; Cummins ; Detroit Diesel ; Deutz ; GM ; Isuzu ; Iveco ; John Deere ; Kubota ; MAN ; MTU ; Perkins ; Scania ; Sius ; Volvo Penta ; Yanmar and others.
Messages of alarms and operation informations are reported directly on the display

Inputs and Outputs
- Pick-Up RPM
- 4 Digital inputs prog.
- 4 Digital outputs prog. ( 2 with relais 10A)
- 8 Analogic inputs
n.3 configurables (VDO)
n.3 configurables (0 - 20 mA)
n.1 configurable (0 - 2400 Ohm)
n.1 configurable (0 - 10 V)
- 2 analogic outputs (0 - 5 V)
- CanBus J1939

Inside Composition
-
Automatic electronic battery charger self-regulated and self-protected
- Relay decoupler for pressure switch NA - NC
- Fuses protection
- Terminal block

Carpentry Schneider Ral 7035
Dimensions : mm 400 x 500 x 200( B. x H. x P.)

Scarica la brochure con i prodotti Tecnocontrolli (ITA)

Tecnocontrolli (4,12 Mb)

Tecnocontrolli brochure prodotti